I used this to mount a Sanyo PLV-Z2 projector.It works great and I am very pleased now that it is up on the ceiling.The mount works by having little arms screwed into the middle that protrude out to the mounting holes on the projector.They do provide several short arms, several medium length, and several long ones.It can be tricky to select the correct lengths, since selecting ones that are too long cause them to interfere with each other.It does not come with mounting screws, though they provide so many screws that it is probably possible to just use some of the extras.I used some of my own that I had lying around the house.
The instructions are vary vague, but not impossible to figure out.I gave this 4/5 stars solely based on the poor instructions, otherwise it would be 5/5.My main complaint is that they provide a package full of screws.There are several pouches with 4 screws each (all marked A, B, C, and so on up until I or J) but the sizes are not marked anywhere!I came to the conclusion that A, B, C, were all the same size (just different lengths) and the same with D, E, F and so on.I'm still not sure that's accurate but I wound up finding screws that seemed to fit and used them.
Adjusting the mount with the projector on it was a bit tricky, but I don't believe this is anything specific to this mount.I have a screen and previously had the projector sitting on a shelf I mounted on the wall opposite the screen.I remember it took a long time to adjust it even on the shelf to exactly fit the screen.Adjusting the image to fit the screen will be a bit painful no matter which mount you choose.
I would recommend having a ladder so that you can be sure to see and reach everything without having to stretch yourself.All in all this took me about 3 hours from start to finish.This includes finding the correct screws, finding the correct lengths for the arms and attaching them, drilling into the ceiling for the mount (make sure to use a stud), and then mounting and adjusting the picture to fit the screen.If I had to do it again, I could probably get it done in 60-90 minutes (most of which would be adjusting the picture to perfectly fit a screen).
Make sure to mount it as close to the center of the screen as possible.Shifting it left/right or up/down WILL distort the picture.The further you shift it, the more distortion you will get.Fortunately, most projectors provide options in the menu that will allow you to fix the distortion (up to a certain point) and make the screen rectangular again.The closer you mount it towards the center of the screen, the less time you need to spend fixing the distortion.
Finally, be sure to mount the projector somewhere on the ceiling where fans, light fixtures, etc. will not be obstructing the image.
Click Here to see more reviews about: Atdec TH-WH-PJ-FM Telehook Universal Projector Flush Mount
Product Description:
The Telehook Universal Projector Flush Mount is exceptionally versatile, and its works well with most projectors weighing up to 33 pounds. It features a 5-inch minimum distance from the ceiling, and can be rotated a full 360 degrees. This white colored mount also features a quick-release mechanism that allows for easy maintenance and installation. This product is protected by a 5-year limited warranty.
Buy cheap Atdec TH-WH-PJ-FM Telehook Universal Projector Flush Mount now Get 22% OFF
0 comments:
Post a Comment